Our gantries (LG) can be used for both balanced cantilever as well as for infill span-by-span erection. Depending on the project dry joint or wet joint erection is required.

• Featuring segmental bridges with dry or glued joints, using erection methods like infill-spans and balanced cantilever.
• Special hinged overhead gantries (with up to 6 hinges) have been supplied to accommodate tight horizontal curvature, down to 100m radii.
• Side-launching of gantry to accommodate erection of separate parallel double and triple tracks, as well as bifurcation spans.
• Vertical climbing of gantries to allow access for side shifting to neighbouring bridges, and to accommodate tight vertical curvature and steep longfall.
• Fully and partly final post-tensioning carried out while the whole span is still suspended to the gantry, without need to use special plunger arrangement at each end.
• "Glue-as-you-go", erecting segments without any or only limited double handling.
• Balanced cantilever and infill-span erection with same gantry.
• Cranes capable of walking through hinged transitions (also noses).
• Gantry can lift and adjust whole span in level and line
  (vertical and transverse adjustment)
• Gantry is selflaunching, transports also supports by its own crane.
• Aux. equipment for erecting pre-cast wings at 2^nd stage ( if needed).